This product is no longer in stock
|Clamp Meter Type||AC & DC|
|Clamp Meter Max Current||1000A|
|Clamp Min Resolution||10mA|
Accurately analyze non-sinusoidal waveforms and noisy signals in VFD-controlled equipment.
Locate noise from different electrical draws to realign harmonics and reduce electro-mechanical equipment stress.
Analyze three-phase systems to measure power draw and verify if power is evenly balanced.
Measure hard and soft start-up inrush current spikes while equipment is ramping up.
Embed electrical measurements into thermal images captured by METERLiNK-enabled FLIR IR cameras for easier documentation.
Monitor power quality improvements, such as start-up realignments on three-phase equipment.
Connect to Android devices for remote diagnostics in hard-to-reach or hazardous areas. Also, upload data without the need for special cords.
Make your work safer/easier in poorly lit locations – especially useful when the lights are out or obstacles block your inspection targets.
Double-molded case design and extra thick rubber on the corners absorbs shock to enhance job-site reliability and long-haul durability.
|AC/DC Current||1000 A||+/- 2%|
|AC/DC Voltage||1000 V||+/- 1% / 0.7%|
|AC VFD Voltage||1000 V||+/- 1%|
|Harmonics||1st-25th Order||+/- 5%|
|Total Harmonic Distortion||0.0 to 99.9%||+/- 3%|
|Inrush Current||1000 ACA Max (Integration Time 100 ms)||+/- 3%|
|Active Power||10 kW to 60 kW, (10 V, 5 A min)||+/- 3%|
|Diode Test||0.4 to 0.8 V||+/- 0.1V|
|Capacitance||3.999 mF Max||+/- 1.9%|
|Resistance||99.99 kΩ Max||+/- 1%|
|Continuity Threshold||30 Ω||+/- 1%|
|Frequency||20.00 Hz to 9.999 kHz||+/- 0.5%|
|Jaw Opening||45 mm (1.77”)|
|Category Rating||CAT IV-600V, CAT III-1000V|
|Bluetooth Range Max||10 m (32ft)|
|Battery Type||6 x AAA|